At present, the most vulnerable areas for home improvement are the "sensitive areas" of all wood products, latex paint walls, and bathroom waterproofing. The quality disputes caused by these three aspects account for more than 80% of the total home decoration complaints. Therefore, when you carry out home improvement, you must pay special attention to the “sensitive areas†of these renovations.
Ding Huan Wood Furniture Changi Home Plate Furniture Thousands of Bird Furniture
First, the wood deformation: to maintain stable water content
A large number of wood products used in home improvement, such as curtain boxes, heating covers, fixed furniture, wooden lines, door and window covers, etc. Once the temperature and humidity in the room change greatly, some wood products will suffer from problems such as cracking, warping and deformation. It is due to the problem of the moisture content of wood. Generally, the moisture content of wood materials should be about 8%.
Experts advise: The use of artificial boards is more, the wood-based panel is to decompose wood into wood chips or wood pulp, and then re-make the board, because the original physical structure of the wood is broken, so when the temperature and humidity change greatly, the artificial board " "Deformation" is much smaller than solid wood. In addition, after all the wood products are installed, they must be painted once, not only to protect the wood products, but also to maintain the normal moisture content of the wood. All the timber should be placed for a few days after entering the site so that the moisture content of the wood is close to that of the new home. If wood products are near wet bathroom walls, be sure to apply 1-2 coats of paint on the back of the wood before installation. This will reduce wood deformation.
Second, cracking insulation wall: the use of decoration methods
Many new homes have new insulation walls with insulation. This type of wall decoration is very vulnerable to the problem of cracking latex paint. Mainly due to cracks in the walls of the cement, or cracks in the "insulation board" joints.
Experts advise: When dealing with the wall base, the first part of the crack chisel into "V"-shaped seams, then use "elastic putty" smooth, and then paste a layer of Dacron, kraft paper or bandage on the wall, the use of fiber Tension to ensure the integrity of latex paint film, this approach is relatively simple and easy, but the effect is general; either the wall surface insulation board removed, or remove the cement wall, in the insulation layer first install a layer of gypsum board Or "cement pressure plate", and then scrape putty on the top to do latex paint, this practice can remove all the irregular cracks, but this method is costly, construction is difficult; In addition, the use of flexible decorative materials For example, "elastic putty" can compensate the wall cracking problem to some extent.
Third, the bathroom leaks: corners smeared in place
Many families in the renovation, the original bathroom tiles should be destroyed, laying new tiles, so you need to do a waterproof project in the bathroom wall, if there is a quality problem in the waterproof project, there will be leakage of trouble .
Experts advise: If you want to replace the bathroom floor tiles, in the original floor tiles chisel away, we must first use the cement mortar to level the ground, and then do the water treatment 2-3 times, and then do the closed water test more than 48 hours; bathroom wall The joints between the ground and the joint between the upper and lower water pipes and the ground, all waterproof paint must be applied in place; in the waterproof treatment, the wall is also about 30 cm high waterproof coating. The tiles must be tiled first, and the next row of tiles must be pressed on the tiles so that the water in the walls can be prevented from penetrating into the ground. However, if the bathroom wall is a non-load-bearing light wall, the entire wall should be painted with waterproof paint.
Links: Flooring Paving Careful How to Accept Paving
Construction Acceptance Paint Home Decor Lacquer Furniture Cement Floor Tiles Panel Furniture Toilet Waterproof Bathroom Wall Tiles Bathroom Tiles Bathroom Tiles Bathroom Doors Decoration Home Tiles Floor Tiles Decoration Home LD Tiles
Refers to the part between the connected part and the nut. Generally, flat metal rings are used to protect the surface of the connected parts from being scratched by the Nuts and to disperse the pressure of the nut on the connected parts.
The gaskets are divided into: flat washer - C, large washer - A and C, extra large washer - C, small washer - A, flat washer - A, flat washer - chamfered - A, high strength washer for steel structure, spherical washer, conical washer, square bevel washer for I-beam, square bevel washer for channel steel, standard spring washer, light spring washer, heavy spring washer, internal tooth lock washer Internal serrated lock washer, external serrated lock washer, external serrated lock washer.
Spring Washer,Flat Washers,Grade A Washers,Bonded Seal Washers
Suzhou Gubao Screws Co.,Ltd. , https://www.gbscrewes.com