SKF imported bearing selection tips

Source: Bearing network time: 2014-02-16

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

The role of SKF's imported bearing cooperation is to make the stop ring and the rotating ring of the SKF imported bearing and some of the stop of the device (usually the bearing seat) and some of the rotation (usually the shaft) are fixed together; The basic task of loading and limiting the motion system relative to the stopping system orientation.
On the shaft and in the bearing housing; SKF imported bearings need to fix their orientation in three directions: radial, axial and tangential directions. The radial and tangential positioning is completed by the tight cooperation of the SKF imported bearing rings; As long as the positioning is selected in a small number of cases, the axial limit parts are usually selected; for example, the end cover and the retaining ring limit the axial orientation within the clearance range.
When selecting cooperation, we should focus on the following four points:
(1) The circumferential surface of SKF imported bearing rings should have outstanding support and uniform force; to reduce deformation; and give full play to the bearing capacity of SKF bearings.
(2) The ferrule cannot slide in the direction of the tangential direction in its cooperation appearance; otherwise, the cooperation surface will be damaged.
(3) It is necessary to import the bearings of SKF at the free end with the change of the length of the bearing shaft of the shaft and SKF; that is, it is necessary to have the ability to swim in a certain range with the customary axial orientation.
(4) It is necessary to pay attention to SKF imported bearing device and open and concise; save labor and save time and money.

Recommend to friends comments close window

Bearing related knowledge

The correct equipment to import bearings, the details of the "feel" bearing--BMH sensor bearing automotive bearing device, application and protection knowledge how to install the ball bearing low-noise bearing selection trick analysis

This article links to http://
Please indicate China Bearing Network http://

Previous: Anatomy: The reason for affecting the grinding layer of FAG bearing grinding Next: FAG bearing equipment: fixed support with two ends adjustable

Forstner Bits

Forstner bits, flat-bottomed to drill holes in wood materials, they can cut on the edge of a block of wood, and can cut overlapping holes; for such applications they are normally used in drill presses or lathes rather than in hand-held electric drills. Because of the flat bottom of the hole, they are useful for drilling through veneer already glued to add an inlay.

The bit includes a center point which guides it throughout the cut (and incidentally spoils the otherwise flat bottom of the hole). The cylindrical cutter around the perimeter shears the wood fibers at the edge of the bore, and also helps guide the bit into the material more precisely.

Forstner bits have radial cutting edges to plane off the material at the bottom of the hole. The bits shown in the images have two radial edges; other designs may have more. Forstner bits have no mechanism to clear chips from the hole, and therefore must be pulled out periodically.

3 (13)

Forstner Bits,bosch forstner bits,colt forstner bits

Behappy Crafts (suzhou)Co.,Ltd , https://www.behappyindustry.com