In the home improvement process, the paving effect of the floor tiles will affect the entire interior environment, so the paving of the floor tiles is very important, so how to tile the floor tiles is better? Next, I will take a look at the correct brick paving together with Xiao Bian. Method steps!
Tile paving method step one: tile soaking
First, the purchased tiles are cleaned and soaked in water for more than 2 hours. The tiles are soaked in order to allow the tiles to fully absorb moisture, and to avoid absorbing water from the materials after the tiles are finished, affecting the tiles and the ground. The degree of sticking causes emptying, falling off, etc. Before starting to lay tiles, it is necessary to remove from the water and wipe off the water on the surface to facilitate the laying.
Tile paving method step two: set the auxiliary line
Before starting to tile, you need to hang a vertical line on the wall. The vertical line is used to determine the size of the tile and wall, and then set the horizontal line, so as to ensure the flatness of the tile during the laying process .
Tile paving method step three: set support plank
In the tile laying process, the horizontal line is taken as the criterion, and the wood board is set to support the tiles. This is to prevent the tiles from displacing or falling before reaching a certain adhesion strength.
Tile paving method step four: lay out in order
Usually, the paving of bricks starts from the side of doors and windows or from the balcony. From the top to the bottom, the left and the right are ensured. The water leveling layer is used first. Then the cement is applied to the back of the tiles and then the tiles are set. Stick on the ground, and then tap the tile with a rubber hammer to fill the gap between the wall and the tile. When sticking, make sure that the paste used is not too thick or too thin. If it is too thick, it is not easy to spread. If it is too thin, it will not stick easily.
Such as floor tile laying method step five: cleaning and maintenance
After the local brick shop is plastered, it is necessary to clean the surface stains in time. When the surface pollution is serious, you can use a 10% concentration of diluted hydrochloric acid solution to clean it. If you use diluted hydrochloric acid for cleaning, you must finally use it again. Rinse with clean water again. If it is a tile glaze, you can spray a thin layer of brightener on the surface after cleaning, and use a soft cloth to wipe it again to maintain the gloss of the tile surface and not be easily contaminated.
Xiao Bian concludes: The above is the correct brick laying method steps that Xiaobian has shared for everyone. Since the tiles are not easy to be replaced in a big project, they must pay attention when laying. Hope that the above sharing can help everyone, if you need to know more For related information, please continue to pay attention to the website of this website.
Tile laying method
ASME So Flanges,Carbon Steel Plate Flanges,Astm A105 Flange,Carbon Steel Pipe Flanges
Cangzhou Youlong Pipe Fitting Manufacturing Co., LTD , https://www.ypco88.com