Cycloidal pinwheel reducer installation:
1. When installing the reducer on the basis, calibrate the installation centerline elevation of the reducer, the level and the relevant dimensions of the connected parts. The concentricity of the calibration drive shaft should not exceed the range allowed by the coupling.
2. When the speed reducer is calibrated, it can be carried out with steel blocks or cast iron blocks. The height of the blocks should not exceed three, and it can also be carried out with the iron. However, the gears should be replaced with flat blocks after calibration.
3, the block should be arranged to avoid the deformation of the body, should be arranged symmetrically on both sides of the foundation bolt, the mutual distance can be enough to allow the water slurry to circulate freely during irrigation.
4. When the coupling of the coupling, pulley, sprocket, etc. is added to the output shaft of the cycloid reducer, the direct slamming method is not allowed, because the output shaft structure of the reducer cannot bear the axial slamming force. The shaft end screw hole can be screwed into the coupling member.
5. The shaft diameter of the output shaft and the input shaft is matched with GB1568-79.
6. The lifting eye screw on the reducer is only used for lifting the reducer.
7. The irrigation of cement slurry should be dense, and there should be no air bubbles, voids and other defects.
Inheriting the artistic styles of silverware in Ming and Qing dynasties and combining the application of modern high-end technology,
the mould appearance is made by the 999 fine silver through electroplating after being elaborately manufactured by various procedures.
The glittering, translucent, vivid and gorgeous appearance is endowed intense palace flavors.
Classical Furniture Handle SIL Colour
Silver Colour Handle,Zinc Hardware Handle,Smooth Surface Handle,Curved Silver Zinc Handles
NINGBO ETDZ HOLDINGS LTD , http://www.etdzhardware.com