High viscosity rotor gear pump stick coating process

High viscosity rotor gear oil pump in daily use to keep in mind Electric pump should be placed in dry, clean and non-corrosive gas environment. Keep each part and replace the same parts, the demolition of high-viscosity rotor pump should be retained for each part, pay special attention to the explosion-proof parts of the flameproof parts can not damage the hairline, including insulation pads and casing, if any Damage must be replaced on the same new parts, shall not use less than the raw material function of alternative materials or parts of the original specifications do not match, assembly should be all the parts according to the original location, can not be missed. High-viscosity rotor gear pumps are often fat, electric drum pumps for high-speed operation, easy to volatile grease, so the bearings must be kept clean and pay attention to replacement. High-viscosity rotor pump inspection and maintenance often, electric drum pumps should always be checked and repaired, to check the power cord: the internal wiring, plugs, switches are good, the insulation resistance is normal, the tailstock is loose, commutator and brush Good contact, armature-level expansion stator winding is the phenomenon of a suitable disconnect, bearing and rolling parts are damaged and so on. High-viscosity rotor pump pay attention to insulation resistance, long-term shelved or used in humid environment, electric pump, must be measured before use 500 meter winding insulation resistance. If the insulation resistance between the winding and the motor housing is less than 7, the winding must be dried. High-viscosity rotor gear pump stick coating process is relatively simple, but the actual construction requirements are quite strict, just choose a good adhesive, may not be able to obtain high viscosity strength. It is necessary to select the right adhesive, but also strictly in accordance with the exact method of adhesive coating the right adhesive, but also strictly in accordance with the exact process of law line viscosity coating to get satisfied with the coating effect. In recent years, surface coating technology in China's equipment maintenance has been widely used, for a variety of materials, parts and equipment repair. Its working principle is to add molybdenum disulfide, metal powder, ceramic powder and fiber and other special filler adhesive, directly applied to the surface of materials or parts, so that it has a wear-resistant, corrosion and other functions, mainly for surface strengthening and repair . It's simple process, convenient and flexible, safe and reliable, does not require specialized equipment, just a good glue coated on the surface of the cleaned parts to be cured after the repair can often manipulate at room temperature, will not make the parts Produce thermal equivalent effect and deformation. High viscosity rotor gear pump in daily use focus on routine maintenance work in accordance with certain topics and principles of good control, to fully demonstrate the control and production, get a good way to maintain and extend the service life.

96 Deep Well Plate

Made of medical grade polypropylene, resistant to alcohols and other mild organic solvents.
Can provide sterilization, with lid, independent packaging.
Provide 10ml, 4.6ml, 3.5ml, 2.2ml, 1.6ml, 1.0ml, 1.2ml, 0.5ml, Deep-Well Plate and 96 Deep Well Plate.
It can be sealed with a Sealing Film or a silicone cover.
It complies with the international SBS automation standard and is compatible with the international standard DNA to provide equipment.
The magnetic tip comb, which is usually used along with deep well plate, can be divided into 96 magnetic tip comb and 8 Row magnetic tip comb. Both of the comb tips has different dimension to match the different size of the plate well.

96 Deep Well Plate 2 ml,2.2 ml Deep Well Plate,2ml 96 Well Plate,96 Square Well Plate,96 Deep Well Block

Yong Yue Medical Technology(Kunshan) Co.,Ltd , https://www.yonyue.com