1. After the construction of the pedestal is completed, it needs to be maintained for 7-10 days before being put into use. During the maintenance period, water or other solution should not be allowed to infiltrate the surface.
2. Every employee who enters the workshop must be replaced with rubber-soled shoes (not wearing black shoes with foam bottom) (so as not to scratch the ground when the outside mud is brought into the workshop)
3, all hardware: such as iron chairs, iron tables, iron shelves, etc., their feet should be wrapped with soft plastic, rubber or paper pad to avoid scratching the ground during use
4, the tractor pulls must fully lift the board off the ground, please pay special attention to the corner of the board when turning, do not scratch the ground
5. When cleaning the floor, please use a soft mop with good water absorption or a wet or dry vacuum cleaner. Clean with water or detergent, but please note that the floor is slippery
6, if the use of a long time caused by wear or scratch, a small area can be repaired, if the area is larger, it is recommended to re-roll once
7. Before the equipment enters the factory, lay a hard carton bottom on the floor to avoid scratching the ground during transportation.
8, carts, cart wheels please use hard or elastic rubber wheel, and plant inside and outside use separately
9, according to the requirements of the ground to do waxing (the effect can prevent scratching the ground)
2. Every employee who enters the workshop must be replaced with rubber-soled shoes (not wearing black shoes with foam bottom) (so as not to scratch the ground when the outside mud is brought into the workshop)
3, all hardware: such as iron chairs, iron tables, iron shelves, etc., their feet should be wrapped with soft plastic, rubber or paper pad to avoid scratching the ground during use
4, the tractor pulls must fully lift the board off the ground, please pay special attention to the corner of the board when turning, do not scratch the ground
5. When cleaning the floor, please use a soft mop with good water absorption or a wet or dry vacuum cleaner. Clean with water or detergent, but please note that the floor is slippery
6, if the use of a long time caused by wear or scratch, a small area can be repaired, if the area is larger, it is recommended to re-roll once
7. Before the equipment enters the factory, lay a hard carton bottom on the floor to avoid scratching the ground during transportation.
8, carts, cart wheels please use hard or elastic rubber wheel, and plant inside and outside use separately
9, according to the requirements of the ground to do waxing (the effect can prevent scratching the ground)
Hyundai Parts,Machinery Spare Parts,Hyundai Aftermarket Parts,Dump Truck Spare Parts
JINING SHANTE SONGZHENG CONSTRUCTION MACHINERY CO.LTD , https://www.sdkomatsudozerparts.com